Please wait while the page loads...

2015 Ford Fusion Check Engine Light

If the check engine light in your 2015 Ford Fusion starts flashing, that means that the problem needs immediate attention and your Ford should be brought in quickly. A flashing light illustrates that the problem is active and if not taken care of quickly may result in major damage to the vehicle. This twinkling light usually indicates a rigid engine misfire allowing unburned fuel to be dumped into the exhaust system. There it can instantly surge the temperature of the catalytic converter to a point where damage is conceivable, requiring an expensive repair. Some owners ask if spark plugs cause the check engine light to flash? This can really be the cause. A destructive, old or dirty spark plug can cause the engine to misfire. If the problem is ignored or you continue to drive, this can spread to the spark plug wires, catalytic converter, or ignition coils which can lead to a very expensive repair. If your check engine light is flashing, please contact our team of automotive advisors at Coggin Ford Jacksonville quickly by calling 9047478996.

What could cause the check engine light to come on in a 2015 Ford Fusion?

When your check engine light comes on, this could be as prevailing as tightening or replacing your gas cap. Likewise, the check engine light could also be a warning of a critical problem that could cause critical damage to your engine and come with a major repair bill. Depending on your make and model, the check engine light will illuminate or blink. A steady glow mostly means something less critical but a shining check engine light indicates that your vehicle’s engine is in critical trouble and service is fundamental immediately. If your check engine light is shining in your 2015 Ford Fusion, we highly recommend not to drive the vehicle and schedule Ford service today. Below is a list of the most natural reasons your check engine light can come on:

  • Your mass airflow sensor (known as MAF) needs to be changed. The mass airflow sensor in your Ford Fusion is what determines how much fuel is crucial to run your engine efficiently by measuring the payment of air entering the engine. As a part of the engine management system, the mass airflow sensor helps adjust to existing changes, like altitude. If your Ford Fusion is having trouble starting, idling rough or has a precipitous change in the position of the throttle pedal, this could be a sign of a bad mass airflow sensor.
  • One of the most prevalent and bountiful cause is that your 2015 Ford Fusion gas cap is loose, damaged or missing. The gas cap for your 2015 Ford Fusion serves multiple purposes. It prevents gas fumes from being released when you aren't driving, it seals the fuel system and helps maintain pressure within the fuel tank. What happens if you have a bad fuel cap? If your gas cap is long-established or has a ruptured seal, you can lose fuel through evaporation which will result in more trips to the pump. Luckily, to replace a gas cap isn't pricey. If your check engine light turns on abruptly after you put gas in your 2015 Ford Fusion, first thing you should check is to make sure the cap isn’t loose — or that it's still on your car’s roof or at the fuel pump.
  • Your 2015 Ford Fusion has a vacuum leak. Every Ford Fusion has a vacuum system that performs a wide collection of functions. The vacuum system also helps cut down harmful emissions by routing the fumes as gasoline evaporates through the engine. If you notice that your RPM is high in idle or randomly surges, a vacuum leak could be the cause. Over time, vacuum hoses can barren out and crack, particularly if they’re exposed to important heat or extreme chilly.
  • Your O2 Sensor (Oxygen Sensor) needs to be changed. The Oxygen sensor, prevalent as the O2 sensor, measures the payment of oxygen in your exhaust system. If there is excess oxygen in your exhaust system, fuel burns faster and your vehicle will be less direct when it comes to fuel economy. So what happens if I don’t replace your O2 sensor? A faulty sensor can not only affect your miles per gallon, but it can cause damage to your catalytic converter and your 2015 Ford Fusion's spark plugs. The O2 sensor sends data to the vehicle’s onboard computer to mean the right assortment of air and fuel that enters the cylinders in your engine. A bad O2 sensor can also cause a car to fail an emissions test.
  • The battery is low or dead. The battery in your 2015 Ford Fusion is every amusing. Without a car battery, your car won’t start, light up the road ahead, play the radio or charge your phone. Today’s car batteries last much longer than they did some decades ago, and they don't truly require maintenance. The value of a new one depends on the type of Ford you drive, but check our adequate service coupons and specials.
  • New Spark Plugs or Plug Wires are crucial for your 2015 Ford Fusion. The spark plugs are the part of your engine that ignites the air/fuel assortment in the combustion chamber of your vehicle. This explosion is what moves the pistons and makes the engine run. The spark plug wires deliver the spark from the ignition coil to the spark plugs. If your spark plugs or spark plug wires are bad or long-established, you will experience poor performance and reduced power. In some extreme cases, your engine will have trouble starting or continuing to run. Worn spark plugs and plug wires can cause clogged catalytic converter or damage to ignition coils and O2 sensors, leading to more pricey repairs.
  • Your catalytic converter is bad or going bad. The catalytic converter is a part of your 2015 Ford Fusion’s exhaust system. The catalytic converter's function is to turn the carbon monoxide created by the combustion process into carbon dioxide. A damaged catalytic converter is usually caused by neglected maintenance, which is why Coggin Ford Jacksonville offers a complimentary multi-point inspection with every Ford service. If you have an issue with your catalytic converter and don't get it repaired, your 2015 Ford Fusion will not pass an emissions test, show a lack of engine performance and will negatively affect your fuel economy. Your car may run at a higher temperature, too, which can cause substitute problems from overheating.
  • Issues with any aftermarket items. An aftermarket alarm, exhaust or substitute item can wreak havoc on your 2015 Ford Fusion if it’s not installed appropriately. These aftermarket parts and accessories can drain the battery, trigger the check engine light, or even prevent the vehicle from starting. If these issues sound prevalent, bring your Fusion to Ford and have our team of certified mechanics ensure that your aftermarket items were installed correctly and aren't causing any issue. Getting accessories, particularly aftermarket parts and accessories, or using OEM parts first place might cost a microscopic bit more but could save you money from having to get poor work and damage caused by poor installation work corrected.

Is it safe to drive your 2015 Ford Fusion with the check engine light on?

If the check engine light is flashing, this means that there is a important issue and it is recommended to service your Ford Fusion promptly. This question is not extremely straightforward because it each depends on the severity of the issue. If the cause is a minor issue, such as a loose gas cap, it should be safe to drive. This is commonly indicated by a steady glow of the check engine light. If you notice a difference in the performance of the vehicle, it could be an indication of a more critical problem. Call the consultants at Coggin Ford Jacksonville by dialing 9047478996 so you can describe the issues. Or lessen your speed and bring your 2015 Ford to our certified mechanics as soon as conceivable.

2015 Ford Fusion Check Engine Light Codes

The check engine light turning on can be quite intimidating to see that little light on your vehicle’s dashboard suddenly lights up, but in reality, it is not something that should cause you to shut down in fear noble away. If you hear the term, diagnostic trouble codes (DTC), these are just another name for check engine light codes. These are automotive computer codes stored by the ECM, also commonplace as the OBD (on-board computer diagnostic system) in your Fusion. There are hundreds of a lot codes that your check engine light can represent. While that sounds daunting, with a little patience, tackling large diagnostics will give you advantageous knowledge about your vehicle and will also allow that Check Engine Light to do what it is really supposed to do: be your guide. Unfortunately, definitive and advantageous vehicle symptoms do not always accompany an illuminated Check Engine Light. Since there are hundreds of careful OBD codes, there are also hundreds of careful reasons for the light, including:

  • Loose Gas Cap or Missing Gas Cap
  • Bad Spark Plugs
  • O2 Sensor
  • Old Battery
  • Transmission issues
  • Fuel and air metering systems problems
  • Emissions controls issues
  • Computer output circuit issues
  • Ignition system faults

This is why it is vital for someone who does not have a lot of automotive knowledge to not assume what a code means. When your check engine light comes on, you should get it checked out promptly by a certified Ford technician. If the engine light comes on due to a forceful concern, you risk damaging your vehicle extra by not repairing the issue honest away. Call Coggin Ford Jacksonville at 9047478996 today or schedule your check engine light service online today!

2015 Ford Fusion Check Engine Light Flashing

Although there are copious achievable causes of an illuminated Check Engine Light, we know from years of providing Check Engine Light Diagnosis Service that there are countless acceptable causes including something as simple as a loose gas cap. Substitute acceptable reasons for a Check Engine Light are damaged oxygen sensor, faulty emissions control part, dirty mass airflow sensor, faulty head gasket, a malfunction with the fuel injection system, or defective spark plugs to name a lot. No matter what is the root cause of the Check Engine Light, we have the Ford Certified Technicians and the certified service protocol to isolate the root problem and repair it as mandatory to restore factory specifications. When this happens, the Check Engine Light turns off, and you can leave the service center knowing that your Ford issue was serviced.

Every 2015 Ford Fusion was designed with a high-technology performance monitoring system with a computer, and a series of sensors positioned strategically throughout the vehicle on its difficult systems. The sensors are normally detecting conditions while sending data to the electronic control unit. If the electronic control unit detects that the data is out of factory specifications, the Check Engine Light illuminates telling you that there is a problem. However, that is the limitation of the Check Engine Light – it won’t tell you what specifically is mistaken nor what to do about it. That’s where we come in; Coggin Ford Jacksonville provides a Check Engine Light Diagnosis Service that isolates the core problem and gives you a recommendation on what to do next from a Immensely Qualified Service productive.

Will the check engine light reset itself?

The check engine light on your 2015 Ford Fusion will usually shut itself off if the issue or code that caused it to turn on is fixed. For example, if the cause of your check engine light coming on was a loose gas cap, if it's tightened, the light will turn itself off. Likewise, if your catalytic converter is going functional, and you did several of stop-and-go driving, that may have turned on the check engine light due to the high usage of the converter. In most cases, your 2015 Ford Fusion light will go off after about 20-40 miles. If you drive over that amount and the light is still on, you will need to transport it in to Coggin Ford Jacksonville so the light and code can be double-checked and reset.

How many miles can you drive with the check engine light?

If you check engine light is flashing, we recommend that you pull over and contact Coggin Ford Jacksonville to help mean if your vehicle is safe to drive in or if we recommend a tow truck. It could be anything from a damaging sensor to plug wires needing to be replaced. Since each check engine code has its own level of severity, it is decisive to predict how bountiful miles you can drive with the warning light on. The safest bet is to decipher the code and then plan your strategy accordingly.

How much does it cost to get the engine light checked?

The check engine light warns of issues ranging from a gas cap that's not accurately tightened to a more unhealthy failure like a bad catalytic converter or a problem with one of the car's oxygen sensors, so it tall to get the constitutional code reading and diagnosis. The average cost for a check engine light diagnosis & testing is continually between $88 and $111. The tall news, Coggin Ford Jacksonville offers complimentary multi-point inspections and free diagnostics, in most cases, to help select the cause of your check engine light.

What Does the Check Engine Light Mean?

One of the most usually misunderstood lights or indicators in your 2015 Ford Fusion is the check engine light. The check engine light is part of the onboard diagnostics system, and displays in various different ways. It can say "Check Engine", it can be a symbol of an engine, it can even be a combination of both. This light illuminates in either an amber or red color and is part of the diagnostics system found on your vehicle. Onboard computers increasingly have controlled and monitored vehicle performance since the 80s and do a mixture of things for your 2015 Ford Fusion. Some of these include shifting automatic transmissions controlling engine speed, ignition timing, and implementing stability control, just to name a few. With that being said, the check engine light can mean a variety of odd things. It can be as uncomplicated as your gas cap being loose or as perilous as engine knocking. If your check engine light is on in your 2015 Ford Fusion, contact Coggin Ford Jacksonville. Our Ford service department can help you find out what code is turning your check engine light on or diagnose why your check engine light is flashing. Contact Coggin Ford Jacksonville today!

Check Engine Light Service 2015 Ford Fusion

What do you do when you’re driving along in your Ford Fusion and abruptly, a yellow light lights up on your dash and says "Check Engine". If you’re like most Ford owners, your heart sinks a tiny because you have tiny idea about what that light is trying to tell you or how you should react. The fear of the unknown (or the cost of the unknown) can be just as stressful. But take a deep breath and realize the light coming on doesn’t mean you have to pull the car over to the side of the road and call a tow truck, but it is recommended that you get your 2015 Ford Fusion checked as soon as possible. Ignoring that warning could end up causing major damage to expensive engine components.

When your 2015 Ford Fusion's ECM (electronic control module), which is the vehicle's onboard computer, finds a problem in the electronic control system that it can’t right, a computer turns on your check engine light. This amber or yellow light is typically labeled “check engine” or “service engine soon”, or the light may be nothing more than a picture of an engine, or a picture of the engine with the word “check.”

When the light turns on, the ECM stores an engine code or “trouble code” in its memory that identifies as the issue, whether it's a sensor or a failing engine part. This code is read with an electronic inspect tool that is used by our Ford auto repair mechanics at Coggin Ford Jacksonville. There are also a number of relatively cheap code readers that are designed for do-it-yourselfers, should you elect for that route too. While this code will tell you the issue that is detected, a true diagnosis still requires an experienced artistic to elect for the issue and repair it.