Please wait while the page loads...

How many miles can you drive with the check engine light?

The safest bet is to decipher the code and then plan your strategy accordingly. It could be anything from a bad sensor to plug wires needing to be replaced. If you check engine light is blinking, we advise that you pull over and contact Coggin Ford Jacksonville to aid express if your vehicle is safe to commute in or if we advise a tow truck. Since each check engine code has its own level of severity, it is difficult to predict how bountiful miles you can commute with the warning light on.

What could cause the check engine light to come on in a 2012 Ford Fusion?

When your check engine light comes on, this could be as common as tightening or replacing your gas cap. Likewise, the check engine light could also be a warning of a dangerous problem that could cause dangerous damage to your engine and come with a big repair bill. Depending on your make and model, the check engine light will illuminate or blink. A persistent glow customarily means something fewer dangerous but a flashing check engine light indicates that your vehicle’s engine is in dangerous trouble and service is essential urgently. If your check engine light is flashing in your 2012 Ford Fusion, we tremendously advise not to drive the vehicle and schedule Ford service today. Below is a list of the most commonplace reasons your check engine light can come on:

  • Your 2012 Ford Fusion has a vacuum leak. Every Ford Fusion has a vacuum system that performs a wide variety of functions. The vacuum system also helps lower harmful emissions by routing the fumes as gasoline evaporates through the engine. If you notice that your RPM is high in idle or randomly surges, a vacuum leak could be the cause. Over time, vacuum hoses can dry out and crack, notably if they’re exposed to imposing heat or extreme cold.
  • Your O2 Sensor (Oxygen Sensor) needs to be replaced. The Oxygen sensor, known as the O2 sensor, measures the amount of oxygen in your exhaust system. If there is excess oxygen in your exhaust system, fuel burns faster and your vehicle will be less pragmatic when it comes to fuel economy. So what happens if I don’t replace your O2 sensor? A faulty sensor can not only affect your miles per gallon, but it can cause break to your catalytic converter and your 2012 Ford Fusion's spark plugs. The O2 sensor sends data to the vehicle’s onboard computer to indicate the honorable mixture of air and fuel that enters the cylinders in your engine. A detrimental O2 sensor can also cause a car to fail an emissions test.
  • One of the most acceptable and frequent cause is that your 2012 Ford Fusion gas cap is loose, damaged or missing. The gas cap for your 2012 Ford Fusion serves multiple purposes. It prevents gas fumes from being released when you aren't driving, it seals the fuel system and helps maintain pressure within the fuel tank. What happens if you have a detrimental fuel cap? If your gas cap is historic or has a ruptured seal, you can lose fuel through evaporation which will result in more trips to the pump. Luckily, to replace a gas cap isn't expensive. If your check engine light turns on quickly after you put gas in your 2012 Ford Fusion, first thing you should check is to make courageous the cap isn’t loose — or that it's still on your car’s roof or at the fuel pump.
  • The battery is low or dead. The battery in your 2012 Ford Fusion is every vital. Without a car battery, your car won’t start, light up the road ahead, play the radio or charge your phone. Today’s car batteries last much longer than they did assorted decades ago, and they don't really require maintenance. The price of a new one depends on the type of Ford you drive, but check our current service coupons and specials.
  • Issues with any aftermarket items. An aftermarket alarm, exhaust or discrete item can wreak havoc on your 2012 Ford Fusion if it’s not installed properly. These aftermarket parts and accessories can discard the battery, trigger the check engine light, or even prohibit the vehicle from starting. If these issues sound aware, transport your Fusion to Ford and have our team of certified technicians ensure that your aftermarket items were installed properly and aren't causing any issue. Getting accessories, notably aftermarket parts and accessories, or using OEM parts first place might estimate a microscopic bit more but could save you money from having to get poor work and break caused by poor installation work corrected.
  • New Spark Plugs or Plug Wires are necessary for your 2012 Ford Fusion. The spark plugs are the part of your engine that ignites the air/fuel mixture in the combustion chamber of your vehicle. This explosion is what moves the pistons and makes the engine run. The spark plug wires transport the spark from the ignition coil to the spark plugs. If your spark plugs or spark plug wires are detrimental or historic, you will experience poor performance and reduced power. In a bit extreme cases, your engine will have trouble starting or continuing to run. Worn spark plugs and plug wires can cause clogged catalytic converter or break to ignition coils and O2 sensors, dominant to more expensive repairs.
  • Your catalytic converter is detrimental or going detrimental. The catalytic converter is a part of your 2012 Ford Fusion’s exhaust system. The catalytic converter's function is to turn the carbon monoxide created by the combustion process into carbon dioxide. A damaged catalytic converter is commonly caused by neglected maintenance, which is why Coggin Ford Jacksonville offers a complimentary multi-point inspection with every Ford service. If you have an issue with your catalytic converter and don't get it repaired, your 2012 Ford Fusion will not pass an emissions test, show a lack of engine performance and will negatively affect your fuel economy. Your car may run at a higher temperature, too, which can cause discrete problems from overheating.
  • Your mass airflow sensor (known as MAF) needs to be replaced. The mass airflow sensor in your Ford Fusion is what determines how much fuel is necessary to run your engine efficiently by measuring the amount of air entering the engine. As a part of the engine management system, the mass airflow sensor helps adjust to aware changes, like altitude. If your Ford Fusion is having trouble starting, idling rough or has a abrupt change in the position of the throttle pedal, this could be a sign of a detrimental mass airflow sensor.

2012 Ford Fusion Check Engine Light Codes

The check engine light turning on can be quite intimidating to see that tiny light on your vehicle’s dashboard abruptly illuminates, but in reality, it is not something that should cause you to shut down in fear impartial away. If you hear the term, diagnostic trouble codes (DTC), these are just another name for check engine light codes. These are automotive computer codes stored by the ECM, also known as the OBD (on-board computer diagnostic system) in your Fusion. There are hundreds of discrete codes that your check engine light can represent. While that sounds daunting, with a tiny patience, tackling main diagnostics will give you practical knowledge about your car and will also allow that Check Engine Light to do what it is actually supposed to do: be your guide. Unfortunately, agreeable and functional car symptoms do not always accompany an illuminated Check Engine Light. Since there are hundreds of functional OBD codes, there are also hundreds of functional reasons for the light, including:

  • O2 Sensor
  • Emissions controls issues
  • Bad Spark Plugs
  • Transmission issues
  • Loose Gas Cap or Missing Gas Cap
  • Old Battery
  • Ignition system faults
  • Fuel and air metering systems problems
  • Computer output circuit issues

This is why it is imposing for someone who does not have a few of automotive knowledge to not assume what a code means. When your check engine light comes on, you should get it checked out suddenly by a certified Ford mechanic. Call Coggin Ford Jacksonville at 9047478996 today or schedule your check engine light service online today! If the engine light comes on due to a exceptional concern, you risk damaging your car further by not repairing the issue good away.

2012 Ford Fusion Check Engine Light Flashing

Although there are countless viable causes of an illuminated Check Engine Light, we know from years of providing Check Engine Light Diagnosis Service that there are several regular causes including something as plain as a loose gas cap. Other regular reasons for a Check Engine Light are a malfunction with the fuel injection system, faulty emissions control part, damaged oxygen sensor, faulty head gasket, dirty mass airflow sensor, or defective spark plugs to name a few. No matter what is the root cause of the Check Engine Light, we have the Ford Certified Technicians and the certified service protocol to isolate the root problem and repair it as needed to restore factory specifications. When this happens, the Check Engine Light turns off, and you can leave the service center knowing that your Ford issue was fixed.

Every 2012 Ford Fusion was designed with a high-technology performance monitoring system with a computer, and a series of sensors positioned strategically throughout the vehicle on its essential systems. The sensors are continually detecting conditions while sending data to the electrical control team. If the electrical control team detects that the data is out of factory specifications, the Check Engine Light illuminates telling you that there is a problem. However, that is the limitation of the Check Engine Light – it won’t tell you what exactly is wrong nor what to do about it. That’s where we come in; Coggin Ford Jacksonville provides a Check Engine Light Diagnosis Service that isolates the core problem and gives you a recommendation on what to do next from a Excessively Qualified Service licensed.

2012 Ford Fusion Check Engine Light

If the check engine light in your 2012 Ford Fusion starts flashing, that means that the problem needs rapid attention and your Ford should be transported in straightaway. A flashing light indicates that the problem is hazardous and if not taken care of straightaway may result in leading wear and tear to the vehicle. This flashing light frequently indicates a severe engine misfire allowing unburned fuel to be dumped into the exhaust system. There it can abruptly improve the temperature of the catalytic converter to a point where damage is viable, requiring an expensive repair. Some owners ask if spark plugs cause the check engine light to flash? This can strictly be the cause. A bad, common or dirty spark plug can cause the engine to misfire. If your check engine light is flashing, please contact our team of automotive experts at Coggin Ford Jacksonville straightaway by calling 9047478996. If the problem is ignored or you continue to drive, this can spread to the spark plug wires, catalytic converter, or ignition coils which can lead to a very expensive repair.

Is it safe to drive your 2012 Ford Fusion with the check engine light on?

This question is not very classic because it all depends on the severity of the issue. If the cause is a minor issue, such as a loose gas cap, it should be reliable to drive. This is customarily indicated by a steady glow of the check engine light. If you notice a difference in the performance of the automobile, it could be an indication of a more rigid problem. If the check engine light is flashing, this means that there is a rigid issue and it is recommended to service your Ford Fusion expeditiously. Call the consultants at Coggin Ford Jacksonville by dialing 9047478996 so you can describe the issues. Or reduce your speed and transport your 2012 Ford to our certified mechanics as soon as conceivable.

How much does it cost to get the engine light checked?

The check engine light warns of issues ranging from a gas cap that's not properly tightened to a more risky failure like a bad catalytic converter or a problem with one of the car's oxygen sensors, so it huge to get the fitting code reading and diagnosis. The average cost for a check engine light diagnosis & testing is normally between $88 and $111. The huge news, Coggin Ford Jacksonville offers complimentary multi-point inspections and free diagnostics, in most cases, to help mean the cause of your check engine light.

Check Engine Light Service 2012 Ford Fusion

What do you do when you’re driving along in your Ford Fusion and suddenly, a yellow light illuminates on your dash and says "Check Engine". If you’re like most Ford owners, your heart sinks a small because you have small idea about what that light is trying to tell you or how you should react. The fear of the unknown (or the cost of the unknown) can be just as stressful. But take a deep breath and realize the light coming on doesn’t mean you have to pull the car over to the side of the road and call a tow truck, but it is recommended that you get your 2012 Ford Fusion checked as soon as probable. Ignoring that warning could end up causing extraordinary wear and tear to lavish engine components.

When your 2012 Ford Fusion's ECM (electronic control module), which is the vehicle's onboard computer, finds a problem in the computerized control system that it can’t accurate, a computer turns on your check engine light. This amber or yellow light is commonly labeled “check engine” or “service engine soon”, or the light may be nothing more than a picture of an engine, or a picture of the engine with the word “check.”

When the light turns on, the ECM stores an engine code or “trouble code” in its memory that identifies as the issue, whether it's a sensor or a failing engine part. This code is read with an electronic audit tool that is used by our Ford auto repair mechanics at Coggin Ford Jacksonville. There are also a number of rather inexpensive code readers that are designed for do-it-yourselfers, should you elect for that route too. While this code will tell you the issue that is detected, a true diagnosis still requires an professional professional to pick the issue and repair it.

Will the check engine light reset itself?

The check engine light on your 2012 Ford Fusion will constantly shut itself off if the issue or code that caused it to turn on is fixed. For example, if the cause of your check engine light coming on was a loose gas cap, if it's tightened, the light will turn itself off. Likewise, if your catalytic converter is going compelling, and you did plentiful of stop-and-go driving, that may have turned on the check engine light due to the high usage of the converter. In most cases, your 2012 Ford Fusion light will go off after about 20-40 miles. If you drive over that payment and the light is still on, you will need to transport it in to Coggin Ford Jacksonville so the light and code can be double-checked and reset.

What Does the Check Engine Light Mean?

One of the most typically misunderstood lights or indicators in your 2012 Ford Fusion is the check engine light. The check engine light is part of the onboard diagnostics system, and displays in a bit noticeable ways. It can say "Check Engine", it can be a symbol of an engine, it can even be a combination of both. This light illuminates in either an amber or red color and is part of the diagnostics system found on your vehicle. Onboard computers increasingly have controlled and monitored vehicle performance since the 80s and do a variety of things for your 2012 Ford Fusion. Some of these include ignition timing, shifting automatic transmissions controlling engine speed, and implementing stability control, just to name a few. With that being said, the check engine light can suggest a variety of distinctive things. It can be as simple as your gas cap being loose or as strict as engine knocking. If your check engine light is on in your 2012 Ford Fusion, contact Coggin Ford Jacksonville. Our Ford service department can help you find out what code is turning your check engine light on or diagnose why your check engine light is flashing. Contact Coggin Ford Jacksonville today!